Focus RS Forum banner
1 - 20 of 31 Posts

·
Registered
Joined
·
327 Posts
Fitted my new front under tray today .
Bit Fidely , but once the engine under tray and front grill were off it was far easier .

I used stainless pop rivets and also sprayed a bit of black paint on them to be certain of no rust :smile:
I decided to make some templates of the expensive extension bits out of ply wood I had in the garage , will be making some spares from a carbon sheet :thumbsup: , although I'm hoping I won't need them again :smile:

Very pleased with the end result , firmly fixed this time :smile:
Automotive exterior Air gun Gun accessory Trigger Tints and shades
Rectangle Road surface Asphalt Wood Tar
Rectangle Road surface Asphalt Grey Wood
Automotive tire Bumper Motor vehicle Road surface Automotive exterior
Wheel Tire Car Vehicle Land vehicle
Tire Automotive tire Wheel Motor vehicle Hood
Hood Automotive tire Automotive design Automotive lighting Bumper
 

Attachments

·
Registered
Joined
·
327 Posts
Discussion Starter · #8 ·
What happened to the other one mate for u to change it how you enjoying the RS
Hi Ant
I removed the splitter as can't get on my drive :-(
Will be refitting for shows , my very silly error I never secured the front of the undertray, didn't see the splitter fixings doubled up as front undertray fixings and the tray ripped off on motorway. Expensive error by me :-(

Love the car it's perfect , total credit to you .
 

·
Registered
Joined
·
327 Posts
1 - 20 of 31 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top