Search Results for ‘repair’

Hello everyone, This might be a long shot but just wondering if anyone on here had an old turbo from a MK3 RS? I'm looking for the V band that clamps both sides together. Seems to be impossible to find the exact one otherwise

First time poster but just wanted to share the exceptional service that I recently received from Chris @ Seamline Automotive (https://www.seamlineautomotive.co.uk). I needed a repair to both outside base bolsters on the Recaro CS seats in my Ford Focus RS MK3. Chris responded very promptly to...

Hi all, I've recently bought an UG which is in great condition other than a big chip and scratch from the inside of the front offside wheel arch all the way across the front bumper, about 6 inches long. Don't have a clue how the previous owner managed to do that :facepalm: :laughing: about a...

I've posted this elsewhere but think maybe it's worth a separate post. My car's just had pressure test and result was that need new head + gasket + short block. Apparently it's the worst that they've seen at the dealers (head/cylinders warped). Question is has anyone else had this on the FSA...

Parked up on New Brighton prom and came back to a dented, scraped front end. Absolutely gutted. No note, no apology and no ****s given. So I'm going to need a very good bodyshop Where do I even start? I haven't needed one in 15 years of driving and it seems really hard to validate a good one...

Hey guys, Has anyone got any advice for good place to get my RS re-sprayed? It turns out my RRW has been resprayed before due to damage im guessing. I have just noticed the paint starting to blister and react. The clear coat is also very dry on the whole panel too. It seems my first snow foam...

So, finally got around to fitting my number plate surround onto the rear of my :rs:. I had to drill out both number plate screw captive nuts and replace with new "spider-nuts" (taking a drill to my car - eeek)... but once done, left a much better finish. I've decided I quite like these...

Morning all... I'm wondering if anyone else has come across similar problems with the front bar insert. Obviously with a low car, one expects a few scrapes, but I've encountered a more serious example, given the black portion of the front bar has entirely come loose at the bottom, and the side...